Clean and hot water
Utilization devices, simultaneous demand, remote consumption point pressure and hot water circulation losses are determined.
Mechanical Installation · Plumbing · Çerkezköy and Çorlu
Plumbing, Clean Water and Wastewater Project Planning
We plan domestic water, hot water circulation, waste water, rain water and related plumbing systems in buildings. We evaluate pipe diameter, line pressure loss, vertical column and drainage details as part of the project.
Account and System Design
Technical approach for Plumbing Project
Pressurization of clean water and gravity drainage of wastewater are different design disciplines. It is not correct to apply the same pipe diameter method to every line.
Dirty water and air
Vertical column, horizontal wastewater, ventilation and cleaning access are designed according to the installation load.
rainwater
Rainfalls, collection lines and drainage connections are evaluated according to the roof/drainage area and project rainfall data.
Armature and shaft coordination
Wet volume, floor passage, shaft, meter and maintenance access are coordinated with architecture and other disciplines.
Engineering Process
Four stages from discovery to implementation project
After the project data and existing system conditions are determined, calculations, layout, equipment and field coordination are brought together in the same technical document.
01
Location and device list
Sanitary ware, tap, process connection and roof area information is collected.
02
Flow and drainage design
Clean water demand, hot water circulation, wastewater load and rainwater are calculated.
03
Pipe, column and shaft
Pipe materials, slopes, column placement and service areas are planned.
04
Application drawings
Floor plan, isometric/column diagram, quantity surveying and technical descriptions are prepared.
Before Starting the Project
Information required for preliminary evaluation
Depending on the type of project, the following data may be shared:
- Architectural plan, number of floors and wet volumes
- Number of fixtures and users, usage profile
- Network inlet pressure and water quality information
- Tank, hydrophore and hot water production layout
- Roof areas, drainage levels and connection points
Field and Operation
Things to consider in design
Wastewater, rainwater and clean water circuits are not used interchangeably. Backflow protection, purge connection, venting and appropriate drainage slopes must be addressed on a system-by-system basis.
The regulations to be applied to the project, relevant TS/TS EN standards, equipment manufacturer requirements and employer technical specifications are evaluated together. Design assumptions are verified against the actual conditions of the facility.
Submit Technical Request →Frequently Asked Technical Question
Why is the farthest tap important in clean water installation?
The required dynamic pressure of the consumption point furthest from the entrance or with the most negative elevation is controlled together with all line losses.